Press Products

The AU Die Splitter/Turnover Device is the ideal equipment for testing and spotting dies. The up and down movement of the upper plate is driven through two ball bearing screws connected by two gear motors with two encoders for perfect synchronization. The upper cross member can be rotated by 180° allowing work to be preformed quickly and safely. The hydraulic power unit drives the rotation of the upper cross member and provides the power for the lower plate to slide out of the machinery.

The parallels with “T” slots for die clamping of upper and lower tooling can be moved in order to install dies of different dimensions. These parallels move easy on the ball bearings supports.

Product Videos:

M12
M30
M70 Ribaltatori
M80
M70MF
Montastampi M70 Magnex

Product Catalogs:

Hylatechnik Hyla-Lift is a portable hydraulic die separator cart. The cart is used for die setting and die separation.

The four lifting cylinders have exact parallel motion even with unequal tool loads.  This allows the operator to release the tool jam and lift the upper plate level. The cart is available in three different lifting capacities, 10, 30, or 40 tons.

Product Catalogs:

Hylatechnik Scrap Shear is available as a freestanding unit or mounted directly to the press. Power by a separate hydraulic power unit or use the hydraulics from the press. Actuated control, by either signal or hand/foot pedal switch.

• Max width: 40 inches
• Max thickness: 0.394 inch
• Max speed: 150 spm

Product Catalogs:

Hylatechnik Shock Dampers are designed to protect the press and tooling from server snap through loads. The Hylatechnik dampers will reduce/eliminate: reverse loads, floor vibration, noise and will increase tool life.

Applications include hydraulic presses, mechanical presses and press breaks. The shock dampers are not limited to the press size. They can be used on the largest of machines.

Product Catalogs:

The Hanchen Ratio-Clamp® is a positive rod clamping safety device. The Ratio-Clamp is unlocked by hydraulic pressure. In the event of an electrical/hydraulic power loss, the potential energy of the internal Bellville washers load a conical piston, driving it over the friction fingers resulting in securing the load. “A true self contained safety clamp."

Boasting a retention force of up to 101,000 lbf., the clamp hydraulically holds the piston rod in whatever position it is in at that particular moment without having to generate extra power (no extra energy) for an unlimited period of time. The clamping device Ratio-Clamp is approved by the German Technical Inspection Agency (TÜV). Special development of Custom solutions (larger rod diameters, intermediate size, greater clamping forces) pose no problem for the Hanchen specialists.

Hanchen is particularly proud of its RC-H model. Following a request from the Health and Safety Centre of the Employers' Liability Association (BGZ iron and metal section III, Düsseldorf), Hänchen developed the new safety clamping hydraulic Ratio-Clamp under extreme conditions for use with hydraulic presses and injection molding machines.

The Hanchen Rod Clamping Device meets the OSHA CFR 1910.217(d)(9)(iv) and ANSI B11.1-2001 standards for preventing the movement of the dies when adjustments and repairs are preformed or when humans are under the dies. This is an excellent alternative to safety blocks as it allows the flexibility to hold the die anywhere in its stroke and also immediately stops and holds the dies for an emergency or power loss.

Product Catalogs: