Hydraulic Pressure Intensifiers – MP-2000-XP Series

MP-2000 Picture

The MP-2000-XP pressure intensifier is made for installation in smaller power packs, where a higher end pressure is required, e.g. for a bolt tensioner.  The available ratios of 7:1, 10:1 and 13:1 allows end pressures proportionally of up to 37,700 psi / 2,600 bar to be generated, from a power pack laid out for 200 bar / 2,900 psi max. and a flow rate from 2 to 13 LPM / 0.5 to 3.96 GPM.

When the XP-intensifier is connected to P and T, it will automatically increase the supplied pressure proportionally to the required end pressure. For evacuation of the high pressure side a pilot operated check valve is integrated, and when activated, the flow from the high pressure side is led through a separate side port directly to tank, where it will be cooled and filtered before being pumped back in the hydraulic circuit. Below the dimensions and circuit of the intensifier with the oil flow direction is shown.

Ratio Min. Inlet Flow Max. Inlet Flow Outlet Flow Q1 Outlet Flow Q2 Min. Supply Pressure Max. Supply Pressure Max. Output Pressure
(i) (GPM / LPM) (GPM / LPM) (GPM / LPM) (GPM / LPM) (PSI / BAR) (PSI / BAR) (PSI / BAR)
7.0  0.5 / 2 3.4 / 13  0.29 / 1.1  0.05 / 0.2 218 / 15 2,900 / 200 20,300 / 1,400
10.0  0.5 / 2 3.4 / 13  0.18 / .07  0.05 / 0.2  218 / 15 2,900 / 200 29,000 / 2,000
13.0  0.5 / 2 3.4 / 13  0.13 / /05  0.02 / 0.1  218 / 15 2,900 / 200 37,700 / 2,600

Weight: 5.94 lbs / 2.7 KG

 

Product Catalogs:

PDF IconScanwill 2000-XP-Pressure Intensifier
PDF IconScanwill Pressure Intensifiers

 

Go back to hydraulic pressure intensifiers overview page >

Go back to reciprocating-type pressure intensifiers overview page >

Go back to reciprocating-type pressure intensifiers accessories page >

Be Sociable, Share!